This time frame can be increased in length or brought down to 0 seconds. Current is NOT taken from the input battery and given to the output battery except during the low voltage timer for regenerative braking mode. Pre-set Charge Profiles and one user customizable battery charging profile available. Simply connect in between a starting battery and house bank and any time the vehicle’s alternator is running this smart charger will smart charge the output bank. The power of load will be maximum during 30 minutes then the power will be reduced to 13A to allow a good thermal dissipation (totally waterproof case).24v input at up to 35 amps and output is 24v at up to 35amps. This totally waterproof model has electronics embedded in the epoxy, which allows it to be IP68 waterproof. Its assembly is simple and this model ensures the optimal recharging of a 24V battery bank from a 24V battery bank. The battery charger with battery allows to recharge much more quickly and completely a park of batteries from the alternator. This charger will be replaced in 2022 by its new version: ABBW242415 It is compatible with the Euro 6 standard (regenerative brakes) and is easy to install even in this case. Compared to the previous generation, it incorporates the possibility of reducing the charging voltage independently of the alternator voltage (some current alternators have a charging voltage that is too high to ensure the recharging (especially during maintenance) of the service batteries. This new model has the same characteristics as the previous range in a more compact housing. The current entering the battery bank is limited by the nominal value of the device. It allows the efficient charging of the connected battery bank from the alternator. The battery charger is connected in the same way as a relay. You can also consult the product sheet which will give you an overview of our range of products dedicated to the optimization of the charging of service battery fleets. Note also that the battery chargers allow to limit the current, this feature is useful to respect the charging constraints of the Lithium batteries or to limit the output power of the alternator and to preserve it from a premature wear. Some models provide voltage conversion, so it is possible to recharge a 24 V battery such as the bow thruster from a 12 V alternator or recharge a 12 V service battery directly from a 24 V alternator. Like the alternator charger, it ensures optimal charging of service batteries from the alternator and is very easy to install. The battery to battery charger is a product that has become increasingly popular in recent years, with Sterling's range, which is by far the most comprehensive on the market, expanding considerably to meet this growing demand. Its assembly is simple and some models ensure voltage conversions. The battery charger with battery allows to recharge quickly and completely a service park from the alternator. More information about the battery charger. This model requires the installation of a plus contact to ensure this compatibility.Īllows to reduce the charging voltage of some alternators having a too high charging voltage in particular during the floating phase Supplied with 1.5 meters of cable (positive and negative) protected by fuse to ensure connection to each batteryĬompatible with all types of batteries including lithium (9 cycles available) and alternatorsġ3A independent of the alternator power (limits the current which is useful for some batteries especially lithium)Ĭompatible with regenerative brakes. No need to dismantle the alternator (connection similar to that of a relay) Three-phase charging cycle (IUoU) with temperature compensation (temperature probe supplied) Fast (2 to 5 times faster) and complete recharge of the batteries from the alternator
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |